2006 BMW M5 Owner's Manual - Page 96

Practical interior accessories The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. You can operate the system when the engine is running or when the ignition is switched on. If the device can not be used after repeated programming, check whether the original hand-held transmitter uses an alternating-code system. To do so, either read the instructions for the original hand-held transmitter or hold down the programmed memory button 1 of the integrated universal remote control. If the LED 2 on the integrated universal remote control flashes rapidly for a short time and then remains lit for approx. 2 seconds, this indicates that the original hand-held transmitter uses an alternating-code system. In the case of an alternating-code system, program the memory buttons 1 as described at Alternating-code transmitters.< The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. If you have any additional questions, please contact your BMW center.< Deleting stored programs Press both outer memory buttons 1 for approx. 20 seconds until the LED 2 flashes: All stored programs are deleted. Individual programs cannot be deleted. Sun blinds* Sun blind for rear window Alternating-code transmitters To program the integrated universal remote control, consult the operating instructions for the equipment to be set. You will find information there on the possibilities for synchronization. When programming hand-held transmitters that employ an alternating code, please observe the following supplementary instructions: Programming will be easier with the aid of a second person.< 1. Park your vehicle within the range of the remote-controlled device. 2. Program the integrated universal remote control as described above in the section Fixed-code hand-held transmitters. 3. Locate the button on the receiver of the device to be set, e.g. on the drive unit. 4. Press the button on the receiver of the device to be set. After step 4, you have approx. 30 seconds for step 5. 5. Press the programmed memory button 1 of the integrated universal remote control three times. Press the button on the driver's door. Sun blinds for rear side windows Pull the loop of the roller sun blind and hook onto bracket. 94 Online Edition for Part No. 01 41 0 012 213 - © 02/06 BMW AG