2012 Dodge Challenger Owner Manual - Page 163

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 161 5. Press and hold the programmed HomeLink௡ button. The EVIC will display "CHANNEL # TRANSMIT". If the device is plugged in and activates, programming is complete. Using HomeLinkா To operate, press and release the programmed HomeLink௡ button. Activation will now occur for the programmed device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lightIf you unplugged the garage door opener/device for ing, etc.,). The hand-held transmitter of the device may programming, plug it back in at this time. also be used at any time. Reprogramming A Single HomeLink௡ Button Security To reprogram a channel that has been previously trained, It is advised to erase all channels before you sell or turn follow these steps: in your vehicle. 1. Turn the ignition switch to the ON/RUN position. To erase the channels press and hold the two outside 2. Press and hold the desired HomeLink௡ button until HomeLink௡ buttons (I and III) for up 20 seconds. The the EVIC displays "CHANNEL # TRAINING" Do not Electronic Vehicle Information Center (EVIC) will display release the button. "CLEARING CHANNELS". Release the buttons when the EVIC displays "CHANNELS CLEARED". 3. Without releasing the button proceed with "Canadian/Gate Operator Programming" Step 2 and The HomeLink௡ Universal Transceiver is disabled when follow all remaining steps. the Vehicle Security Alarm is active. 3