2009 Mercedes CL-Class Owner's Manual - Page 550
2009 Mercedes CL-Class Manual
Page 550 highlights
Practical hints Flat tire sure the jack arm is fully seated in the jack take-up bracket. The jack must always be vertical when in use, especially on inclines or declines. The jack is intended only for lifting the vehicle briefly for wheel changes. It is not suited for performing maintenance work under the vehicle. To help avoid personal injury, use the jack only to lift the vehicle during a wheel change. Never get beneath the vehicle while it is supported by the jack. Keep hands and feet away from the area under the lifted vehicle. Always lower the vehicle onto sufficient capacity jackstands before working under the vehicle. Always firmly set the parking brake and block the wheels with wheel chocks or other sizeable objects before raising the vehicle with the jack. Do not disengage the parking brake while the vehicle is raised. Make sure that the ground on which the vehicle is standing and where you place the jack is solid, level and not slippery. If necessary, use a large underlay. On slippery surfaces, such as tiled floors, you should use a non-slip underlay, for example a rubber mat. Do not use wooden blocks or similar objects to support the jack. Otherwise the jack may not be able to achieve its loadbearing capacity if it is not at its full height. Never start the engine when the vehicle is raised. Also observe the notes on the jack. X G Warning! Only jack up the vehicle on level ground or on slight inclines/declines. Otherwise, the vehicle could fall off the jack and injure you or others. Prevent the vehicle from rolling away by blocking wheels with wheel chocks or other sizeable objects. One wheel chock is included with the vehicle tool kit (Y page 472). For information on setting up the collapsible wheel chock, see (Y page 473). Place the wheel chock in front of and another wheel chock or other sizeable object behind the wheel that is diagonally opposite to the wheel being changed. 1 Wheel wrench X When changing wheel on a level surface: X Always try lifting the vehicle using the jack on a level surface. However, should circumstances require you to do so on a hill, place the wheel chock and another sizeable object as follows: X On wheel to be changed, loosen but do not yet remove the wheel bolts (approximately one full turn with wrench 1). The jack take-up brackets are located directly behind the front wheel housings and in front of the rear wheel housings. Place wheel chocks or other sizeable objects on the downhill side blocking both wheels of the axle not being worked on. G Warning! The jack is designed exclusively for jacking up the vehicle at the jack take-up brackets. 548