Adaptec 5325301656 Administration Guide - Page 151

Off-the-Shelf Backup Solutions for the Snap Server Installing the CA BrightStor ARCserve Agent This section explains how to install the CA BrightStor ARCserve Agent versions 11.5 and 12.0. Note This procedure assumes that you are using the default Snap Server configuration; and you have created a directory called agent (to which to copy your agent/client files) on the default share (SHARE1), such that the path to the directory is /shares/SHARE1/agent. Note Installing the BrightStor ARCserve backup agent on a Snap Server requires three agent (*.rpm) files. These agent files are available from your BrightStor ARCserve CD, but some ARCserve CDs may not contain all the required files. To obtain the files you need, contact Computer Associates. If you have questions about the agent configuration, refer to your CA ARCserve documentation. Prepare the Snap Server 1 Connect to the Snap Server via SSH. Note SSH v2 is required. If you fail to connect to the server, ensure that your SSH client is configured to connect via SSH v2. 2 At the prompt, log in as admin, using the password you created for this account during the initial setup of the server. 3 You are placed into the CLI shell. However, a standard Linux shell must be used to install the agent. To launch a shell, type the following command and press Enter: osshell 4 To change to superuser, enter the following command, and press Enter: su 5 At the prompt, enter the admin user password, and press Enter. 6 To change to the agent directory, type the following command and press Enter: cd /shares/SHARE1/agent 7 To unpack the tar file to get the agent files, type the following command and press Enter: tar -zxvf Linux.tar.Z Note If you later delete the volume this directory is on, you will need to reinstall the agent. Appendix A Backup and Replication Solutions 137