Adaptec 5325301656 Administration Guide - Page 159

Off-the-Shelf Backup Solutions for the Snap Server 4 Remove the NetBackup services by deleting the files for bpcd, vnetd, vopied, and bpjava-msvc in the /etc/xinetd.d/ directory. rm -rf /etc/xinetd.d/bpcd rm -rf /etc/xinetd.d/vnetd rm -rf /etc/xinetd.d/vopied rm -rf /etc/xinetd.d/bpjava-msc 5 Restart the Snap Server services by either rebooting or typing: /etc/rc.d/init.d/xinetd reload Installing the EMC Legato NetWorker Client Note This procedure assumes that you are using the default Snap Server configuration; and you have created a directory called agent (to which to copy your agent/client files) on the default share (SHARE1), such that the path to the directory is /shares/SHARE1/agent. This section describes how to install the EMC Legato NetWorker UNIX/Linux client, as well as special procedures EMC Legato NetWorker users must follow in order to perform backup and restore operations on the Snap Server. Prepare the Snap Server 1 Connect to the server over SSH. Note SSH v2 is required. If you fail to connect to the server, ensure that your SSH client is configured to connect via SSH v2. 2 Log in as admin (using the password for the admin account). 3 You are placed into the CLI shell. However, a standard Linux shell must be used to install the agent. To launch a shell, type the following command and press Enter: osshell 4 Change to root by entering the following command: su Give the root password (same as admin password). Appendix A Backup and Replication Solutions 145