Brother International 9870 Service Manual - Page 69
If the CCD lock is placed in the lock, Set the CCD lock in the release forward position.
View all Brother International 9870 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
n Reassembling Notes • Route the panel harness and CCD HP sensor harness through the three notches, then tape them as illustrated on the previous page. • When replacing the CCD flat cable with a new one, be sure to arrange the new cable as illustrated below, then route it along the positioning rib as shown on the previous page. • Set the CCD motor back into place with its connector side facing up as shown on page IV-21. When securing the motor with screws "d," be sure to secure the scanner grounding wire also as shown on page IV-21. • Route the CCD motor harness and scanner grounding wire as illustrated below. • Set the CCD lock in the release (forward) position. If the CCD lock is placed in the lock position, the CCD home positioning will fail in the next powering-up sequence. If this happens, turn the CCD lock to the release position. IV - 23