Brother International 9870 Service Manual - Page 85
CAUTION, Reassembling Notes, FU lamp between your fingers
View all Brother International 9870 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
(8) To take out the FU lamp from the heat-fixing unit, remove two screws "c." (9) Unhook the two latches outwards (in the direction of arrows •) with the tip of a flat screwdriver and open the upper cover (arrow ,). The upper and lower covers will become separated from each other. (10) Loosen screw "d" (arrow ƒ). (11) Remove screw "e," slightly lift up the heater roller gear (arrow „), hold the lock plate L of the FU lamp between your fingers, and pull out the FU lamp from the heater roller (arrow ...). CAUTION: Do not touch the FU lamp. If you have touched it, clean it thoroughly with alcohol. "c": Taptite, cup B M3x20 "d": Pan cup M3x6 "e": Taptite, pan M3x10DB n Reassembling Notes • When setting the FU lamp into the heat-fixing unit, be sure to insert the right end of the wire into the lock plate R as illustrated above. IV - 39