Brother International 9870 Service Manual - Page 80
Main Cover, Unhook the two latches with the tip of a flat screwdriver
View all Brother International 9870 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
1.15 Main Cover (1) Remove two screws "a" from the front side of the main cover. (2) Remove two screws "b" from the rear side of the main cover, and then pull corner edges "X" outwards to dislocate the main cover from the main chassis. Make sure that the cutout provided in the main cover is dislocated from the power inlet. (3) Unhook the two latches with the tip of a flat screwdriver, then lift up the main cover. "a" and "b": Taptite, bind S M3x8 n Reassembling Notes • When reinstalling the main cover, route the main-relay (panel) harness, main-relay (CCD) harness, and main-relay (motors) harness through the respective cutouts provided in the main cover, as illustrated above. IV - 34
IV
- 34
1.15
Main Cover
(1)
Remove two screws "a" from the front side of the main cover.
(2)
Remove two screws "b" from the rear side of the main cover, and then pull corner edges "X"
outwards to dislocate the main cover from the main chassis.
Make sure that the cutout
provided in the main cover is dislocated from the power inlet.
(3)
Unhook the two latches with the tip of a flat screwdriver, then lift up the main cover.
n
Reassembling Notes
•
When reinstalling the main cover, route the main-relay (panel) harness, main-relay (CCD)
harness, and main-relay (motors) harness through the respective cutouts provided in the main
cover, as illustrated above.
"a" and "b": Taptite, bind S M3x8