Brother International BAS-343E Instruction Manual - English - Page 61
Troubleshooting, Refer to Skipped
View all Brother International BAS-343E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
14. Troubleshooting 14. Troubleshooting Problem Cause Check Remedy Page Auxiliary work clamp does not rise. Insufficient air pressure Presser lifter air tube is bent or damaged. Auxiliary work clamp regulator setting Presser lifter air tube Adjust the air pressure. 6 Straighten the bend in the tube or replace the tube. Auxiliary work clamp does not drop. Work clamp operation is sluggish. Presser lifter air tube is bent or damaged. Sliding part of the work clamp lubrication Presser lifter air tube Grease the sliding part of the work clamp. 6 Straighten the bend in the tube or replace the tube. Presser lift amount is incorrect. Incorrect position of presser arm lever F. Distance between work clamp and top of needle plate Adjust the work clamp lift amount. 37 Thread wiper does not operate correctly. Interference between thread wiper and work The thread wiper is obstructing the needle. Thread wiper position is incorrect. Clearance between thread wiper and work clamp Clearance between thread wiper and needle tip Thread wiper position Adjust the height of the thread wiper. 38 Adjust the height of the thread wiper. 38 Adjust the operating distance of the thread 38 wiper. Lower thread winds to one side. Bobbin winder thread tension stud height is incorrect. Bobbin winder thread tension stud height Adjust the height of the thread tension stud. 11 Lower thread winding amount is incorrect. Bobbin presser position is incorrect. Thread winding amount Adjust the position of the bobbin presser. 11 Thread slips out of the needle. Stitches being skipped at the sewing start. Uneven upper thread length. Position of shuttle race thread guide is incorrect Refer to "Skipped stitches occur". Upper thread length Position of shuttle race thread guide Refer to "Skipped stitches occur". Adjust the sub-tension. 10 Adjust the position of the 33 shuttle race thread guide Cassette is not ejected. Cylinder pin is not working properly. Sensor is not detecting the cassette. Malfunction of foot switch Turn off the power and check valve 2 manually. Check the indicator lamp status. BAS-343E 54