Brother International Innov-ís 40 Users Manual - English - Page 16
Preparing for Upper and Lower Threading
View all Brother International Innov-ís 40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Preparing for Upper and Lower Threading Winding the bobbin Wind the thread onto the bobbin. 1 a Hook of the bobbin-winding thread guide b Pretention disk c Bobbin winder shaft d Bobbin CAUTION ● Only use the bobbin (part code: SA156, SFB(XA5539-151)) designed specifically for this sewing machine. Use of any other bobbin may result in injuries or damage to the machine. ● The included bobbin was designed specifically for this sewing machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB(XA5539-151)). a This model c b Other model c 11.5 mm (7/16 inch) a b (actual size) Turn on the sewing machine. a Swing up the spool pin, and then remove the d spool cap. a Place the bobbin on the bobbin winder shaft b so that the spring on the shaft fits into the notch in the bobbin. a b b a Spool pin b Spool cap Fully insert the spool of thread for the bobbin e onto the spool pin. Slide the spool onto the pin so that the spool is horizontal and the thread unwinds to the front at the bottom. a Notch b Bobbin winder shaft spring Slide the bobbin winder shaft to the right until c it snaps into place. CAUTION ● If the spool is not positioned so that the thread unwinds correctly, the thread may become tangled around the spool pin. 15