Brother International Innov-ís 40 Users Manual - English - Page 85
Make a cut of about 2 cm 3/4 inch long
View all Brother International Innov-ís 40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
UTILITY STITCHES Position the side cutter so that the side cutter f pin is aligned with the notch in the presser foot holder, and then slowly lower the presser foot lever. Position the fabric. j Position the fabric so that the right side of the cut is on top of the guide plate and the left side of the cut is underneath the presser foot. b a a Notch in presser foot holder b Pin X The side cutter is attached. Raise the presser foot lever to check that the g side cutter is securely attached. Pass the upper thread under the side cutter, h and then pull it out toward the rear of the sewing machine. a a Guide plate Note ● If the fabric is not positioned correctly, the fabric will not be cut. CAUTION ● After adjusting the stitch width, slowly turn the handwheel toward you and check that the needle does not touch the presser foot. If the needle hits the presser foot, the needle may bend or break. Make a cut of about 2 cm (3/4 inch) long i in the fabric at the beginning of the stitching. a a 2 cm (3/4 inch) 84