Brother International Innov-ís 40 Users Manual - English - Page 19
Installing the bobbin
View all Brother International Innov-ís 40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
GETTING READY Installing the bobbin Install the bobbin wound with thread. CAUTION ● Use a bobbin that has been correctly wound, otherwise the needle may break or the thread tension will be incorrect. Turn off the sewing machine (set it to " "). b Slide the latch on the right side of the bobbin c cover to the right, and then remove the bobbin cover. a b ● The bobbin was designed specifically for this sewing machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB (XA5539-151)). c a b a This model b Other model c 11.5 mm (7/16 inch) (actual size) ● Before installing the bobbin or replacing the needle, be sure to turn off the sewing machine, otherwise injuries may occur if the start/stop button is accidentally pressed and the machine starts sewing. Press (needle position button) once or a twice to raise the needle, and then raise the presser foot lever. a Bobbin cover b Latch Insert the bobbin with your right hand so that d the thread unwinds to the left side, and then pull the thread firmly under the tab with your left hand. a a Tab CAUTION ● Be sure to hold down the bobbin with your finger and install the bobbin so that the thread unwinds in the correct direction, otherwise the needle may break or the thread tension will be incorrect. a Needle position button 18