Brother International MFC-9340CDW Quick Setup Guide - English - Page 27

For Wireless Network Users Manual setup from the control panel using the Setup Wizard (Windows®, Macintosh and mobile devices) 18 Set up the wireless settings IMPORTANT You must have the wireless settings you wrote down for your network in step 17-b on page 23 before you proceed. NOTE If you use your machine in an IEEE 802.1x supported wireless network, see Network User's Guide: Using IEEE 802.1x authentication. a On your machine, press . Press Setup Wizard. b When Enable WLAN? is displayed, press Yes. This will start the wireless setup wizard. c The machine will search for available SSIDs. It will take a few minutes to display a list of available SSIDs. If a list of SSIDs is displayed, swipe up or down, or press a or b to choose the SSID you wrote down in step 17-b on page 23. Press OK. NOTE • If the list is blank, check that the wireless access point/router has power and is broadcasting the SSID. Move your machine closer to the wireless access point/router and try starting from a again. • If your wireless access point/router is set to not broadcast the SSID you will have to manually add the SSID name. For details, see Network User's Guide: Configuring your machine when the SSID is not broadcast. d Do one of the following:  If the wireless access point/router of the selected SSID supports WPS and the machine asks to use WPS, go to e.  If you are using an authentication and encryption method that requires a Network Key, go to f.  If your authentication method is Open System and your encryption mode is None, go to g. e To connect your machine using the automatic wireless mode, press Yes. (If you choose No (Manual), go to f to enter the Network Key.) When the Touchscreen instructs you to start WPS, press the WPS button on your wireless access point/router, and then press Next on the Touchscreen. Go to g. f Enter the Network Key you wrote down in step 17-b on page 23 using the numbers and characters on the Touchscreen. NOTE • To enter numbers or special characters, press repeatedly until the character you want to enter appears, then press the character you want. • If you entered a character incorrectly and want to change it, press d or c to move the cursor to the incorrect character, then press . • To enter a space, press Space. • For more details, see Entering Text on page 33. Press OK when you have entered all the characters, and then press Yes to apply your settings. g Your machine will now try to connect to your wireless network using the information you have entered. A connection result message appears on the Touchscreen and a WLAN report will automatically print. If the connection failed, check the error code on the printed report and refer to Troubleshooting on page 30. Press OK. Wireless setup is now complete. A four-level indicator at the top right of your machine's Touchscreen will show the wireless signal strength of your wireless access point/router. 27 Windows® Macintosh Wireless Network