Brother International Quattro 2 6700D Users Manual - English - Page 323
the embroidery frame, and then cut
View all Brother International Quattro 2 6700D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 323 highlights
h Press buttons. to unlock all keys and i Lower the presser foot. j While holding both the upper thread and the bobbin thread, sew a section of the pattern. CREATING BOBBIN WORK (EMBROIDERY) n Using a hand sewing ribbon embroidering needle such needle, pull as a the bobbin thread to the top (wrong side) of the fabric, and then tie the upper thread and the bobbin thread together. k Stop the machine, and thread and the bobbin then tie the upper thread together to secure the threads. Memo • If there is a gap between the start point and end point of the pattern, cut the threads, remove the fabric from the machine, and then use a ribbon embroidering needle to hand sew stitches to connect the starting and ending points. o Remove the fabric from the embroidery frame, and check the finished embroidery. How to Create Bobbin Work l Start sewing again to finish the pattern. m Raise the needle and presser foot, remove the embroidery frame, and then cut the upper thread and the bobbin thread. When cutting the threads, be sure to leave an adequate length of thread so they can be properly secured. a Right side of fabric b Wrong side of fabric 7 p If the desired results could not be achieved, adjust the tension of the bobbin thread and of the upper thread, and then try sewing the pattern again. For more details, refer to "ADJUSTING THE THREAD TENSION" on page 322. Memo • Check bobbin after each bobbin work embroidery pattern is sewn to make sure there is adequate bobbin thread for the next pattern. 321