Brother International Quattro 2 6700D Users Manual - English - Page 325
Troubleshooting
View all Brother International Quattro 2 6700D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 325 highlights
TROUBLESHOOTING TROUBLESHOOTING Several solutions for minor problems are described below. If the problem persists, contact your nearest authorized Brother dealer. ■ The thread was accidentally cut automatically and the bobbin thread is caught inside the machine a Cut the thread near the fabric above the needle plate, and then remove the fabric. a Thread Note • If an embroidery pattern was sewn, remove the embroidery frame. b Remove the bobbin, and then hold it toward the left side of the machine. out CAUTION • Do not pull on the thread with excessive force, otherwise the machine may be damaged. ■ The pattern is misaligned Refer to "ADJUSTING THE THREAD TENSION" and increase the upper thread tension. If the pattern is still misaligned, reduce the tension of the bobbin thread. Example: Decorative Stitch c Lower the presser foot. d Apply slight tension on bobbin thread by holding thread out to the left side of presser foot. Press the "Thread Cutter" button again. a Correct tension b The upper thread tension is too loose, or the bobbin thread tension is too tight. 7 ■ The bobbin thread catches on the tension spring of the bobbin case Sew with no tension applied to the bobbin thread. (Refer to "When tension is not applied to the bobbin thread" on page 312.) How to Create Bobbin Work 323