Brother International Quattro 2 6700D Users Manual - English - Page 67

CHANGING THE PRESSER FOOT CHANGING THE PRESSER FOOT 1 CAUTION • Always press on the screen before changing the presser foot. If is not pressed and the "Start/Stop" button or another button is pressed, the machine will start and may cause injury. • Always use the correct presser foot for the selected stitch pattern. If the wrong presser foot is used, the needle may strike the presser foot and bend or break, and may cause injury. • Only use presser feet made for this machine. Using other presser feet may lead to accident or injury. Getting Ready Removing the Presser Foot d Press the black button on the presser holder and remove the presser foot. foot Press → → → → in this order to display a video example of the operation on the LCD (see page 46). Follow the steps explained below to complete the operation. a Press the "Needle the needle. Position" button to raise a b a Black button b Presser foot holder Attaching the Presser Foot b Press . * If the message "OK to automatically lower the presser foot?" appears on the LCD screen, press OK to continue. → The entire screen becomes white, and all keys and operation buttons are locked. c Raise the presser foot lever. CAUTION • Make sure that the presser foot is installed in the correct direction, otherwise the needle may strike the presser foot, breaking the needle and causing injuries. a Place the new presser foot under holder, aligning the foot pin with the the notch in the holder. Lower the presser foot lever so that the presser foot pin snaps into the notch in the holder. a Notch b Pin 65