Brother International Quattro 2 6700D Users Manual - English - Page 53

k Cut the thread bobbin. with cutter and remove the LOWER THREADING a Turn the main top cover. power to ON and open the b Align the groove in the bobbin with the spring on the bobbin winder shaft, and set 1 the bobbin on the shaft. Getting Ready Memo • When removing the bobbin, do not pull on the bobbin winder seat. Doing so could loosen or remove the bobbin winder seat, and could result in damage to the machine. CAUTION • Setting the bobbin improperly may cause the thread tension to loosen, breaking the needle and possibly resulting in injury. a Groove in the bobbin b Spring on the shaft c Pivot the spool pin so that it angles upward. Set the thread spool on the spool pin so that the thread unwinds from the front of the spool. ■ Using the Spool Pin You can use the main spool pin to wind the bobbin before sewing. You cannot use this spool pin to wind the bobbin while sewing. a Spool pin b Spool cap c Thread spool d Spool felt d Push the spool cap onto the spool pin as far as possible, then return the spool pin to its original position. e While holding the pull the thread up thread with both hands, from under the thread guide plate. a Thread guide plate 51