Canon MX700 MX700 series Quick Start Guide - Page 124
Error Message Appears on a PictBridge Compliant Device, Error Message On, PictBridge Compliant, Device - printer head replacement
UPC - 013803081336
View all Canon MX700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
Error Message Appears on a PictBridge Compliant Device The following are the possible errors that may occur when printing directly from a PictBridge compliant device and the countermeasures to clear them. Note z This section describes errors that are indicated on Canon-brand PictBridge compliant devices. The error messages and operations may vary depending on the device you are using. For errors on non-Canon PictBridge compliant devices, check the error message on the LCD and take the appropriate action to clear the error. For details, see "An Error Message Is Displayed on the LCD" on page 101. z For the errors indicated on the PictBridge compliant device and their solution, also refer to the instruction manual of the device. For other troubles on the device, contact the manufacturer. Error Message On PictBridge Compliant Device "Printer in use" "No paper" "Paper Error" / "Media type error" "Paper jam" "Printer cover open" "No print head" "Waste tank full" / "Ink absorber full" "No ink" / "Ink cassette error" "Ink Error" "Hardware Error" Action If the machine is printing from the computer or warming up, wait until the job ends. When it is ready, the machine starts printing automatically. Load paper in the Rear Tray, and select Continue* in the display on your PictBridge compliant device. * To resume printing, you can also press the OK button on the machine instead of selecting Continue on the camera. z Open the Paper Output Tray. The machine resumes printing. z The Front Tray is selected on the machine. Load paper in the Rear Tray, press the Feed Switch button to select the Rear Tray as the paper source, and then press the OK button on the machine or select Stop in the display on your PictBridge compliant device to print again. For details, see "Changing the Paper Source" on page 13. Select Stop in the display on your PictBridge compliant device to stop printing. Remove the jammed paper, load new paper, press the OK button on the machine, and try printing again. Close the Scanning Unit (Printer Cover) on the machine. The Print Head is not installed or defective. For details on how to resolve the error, see "An Error Message Is Displayed on the LCD" on page 101. The ink absorber is nearly full. For details on how to resolve the error, see "An Error Message Is Displayed on the LCD" on page 101. The ink tank is not installed properly or empty. Check the error message on the LCD and take the appropriate action to resolve the error. See "An Error Message Is Displayed on the LCD" on page 101. An ink tank that was once empty is installed. For details on how to resolve the error, see "An Error Message Is Displayed on the LCD" on page 101. Ink tank errors have occurred. Replace the ink tank. See "Replacing an Ink Tank" on page 80. 120 Troubleshooting