Canon imagePROGRAF iPF770 User Guide - Page 416

Menu Settings iPF770 Menu Settings Menu items are as follows. The printer menu is classified into regular menu items available when no print job is in progress and menu during printing items only available while printing is in progress. see "Printer Menu Operations." ➔P.406 Regular menu Menu during printing Paper Menu Not displayed Ink Menu The same Ink Menu as normal is displayed. Job Menu The same Job Menu as normal is displayed. Set./Adj. Menu A limited Set./Adj. Menu containing the following items is displayed. • Adj. Fine Feed (*1) • Printer Info *1:Only displayed in the menu during printing. Not displayed in the regular menu. For instructions on selecting menu items, see "Menu Operations." ➔P.407 For details on the displayed menu hierarchy, see "Menu Structure." ➔P.410 Control Panel Paper Menu The Paper Menu is not displayed during printing. Printer Menu Load Paper Setting Item Description, Instructions Select either sheets or rolls and load the paper. Eject Paper Choose this item before removing loaded paper. Chg. Paper Type (*1) Change the type of paper loaded. (See "Changing the Type of Paper.") ➔P.325 Chg. Paper Size Change the size of paper loaded. (See "Specifying the Paper Length.") ➔P.326 (See "Paper Sizes.") ➔P.310 ManageRemainRoll Choose On to print a barcode at the end of a roll before you remove it. The printed barcode can be used in managing the amount of roll paper left. Choose Off if you prefer not to print the barcode. (See "Keeping Track of the Amount of Roll Paper Left.") ➔P.331 Paper Details (The type of paper is displayed here.)(*1) Head Height Skew Check Lv. Adjust the Printhead height. (See "Troubleshooting Paper Abrasion and Blurry Images.") ➔P.485 If you print on Japanese paper (washi) or other handmade paper that has an irregular width, choose Loose for a higher skew detection threshold, or choose Off to disable skew detection. However, if paper is loaded askew when detection is Off, note that paper jams or Platen soiling may occur. Cutting Mode Specify whether or not to cut with the standard round-bladed cutter. If you choose Automatic, the roll will be cut automatically using the Cutter Unit, depending on the printer driver settings. Select Eject to prevent printed documents from falling immediately after printing such as when you wait for the ink to dry, etc. Manual prints lines at the cut position instead of cutting after printing. (See "Specifying the Cutting Method for Rolls.") ➔P.333 Cut Speed Choose the cutting speed. The preset selection represents the op- timal cutting speed for the type of paper. We recommend keeping 416 the preset cutting speed. If you use adhesive paper, choosing Slow helps prevent adhesive from sticking to the cutter and keeps the cutter sharp. Trim Edge First Selects whether or not to automatically cut the leading edge of the roll paper when roll paper is loaded. (See "Cutting the Leading Edge of Roll Paper Automatically.") ➔P.337 User's Guide