Cisco 6921 Administration Guide - Page 58
Configuring Startup Network Settings
UPC - 882658277764
View all Cisco 6921 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Configuring Startup Network Settings Chapter 3 Setting Up the Cisco Unified IP Phone Table 3-2 LED Diagnostic Status Hardware Test Power is Ready Flash is Accessible RAM Test Successful Ethernet Test Successful MWI On - - - Hold On On - - Mute On On On - Speaker On On On On 2. The screen displays the Cisco Systems, Inc., logo screen. 3. These messages appear as the phone starts up. - Configuring IP message - Registering 4. The home screen displays: - Current date and time - Primary directory number - Additional directory numbers and speed dial numbers, if configured (Only on Cisco Unified IP Phone 6961) - Softkeys If the phone successfully passes through these stages, it has started up properly. If the phone does not start up properly, see the "Resolving Startup Problems" section on page 9-1. Configuring Startup Network Settings If you are not using DHCP in your network, you must configure these network settings on the Cisco Unified IP Phone after installing the phone on the network: • IP address • IP subnet information • TFTP server IP address • You also may configure the domain name and the DNS server settings, if necessary. Collect this information and see the instructions in Chapter 4, "Configuring Settings on the Cisco Unified IP Phone." 3-14 Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP) OL-19025-01