Cisco 7604 Configuration Guide - Page 214

Identifying AAA Server Groups and Servers Chapter 11 Configuring AAA Servers and the Local Database Step 2 d. If you want to indicate whether accounting messages are sent to a single server (single mode) or sent to all servers in the group (simultaneous mode), use the accounting-mode command. For more information about this command, see the Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Command Reference. For each AAA server on your network, perform the following steps: a. Identify the server, including the AAA server group it belongs to by entering the following command: hostname(config)# aaa-server server_tag [(interface_name)] host server_ip [key] [timeout seconds] When you enter a aaa-server host command, you enter aaa-server host configuration mode. b. As needed, use host mode commands to further configure the AAA server. The commands in host mode do not apply to all AAA server types. Table 11-2 lists the available commands, the server types they apply to, and whether a new AAA server definition has a default value for that command. Where a command is applicable to the server type you specified and no default value is provided (indicated by "-"), use the command to specify the value. For more information about these commands, see the Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Command Reference. 11-10 Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM OL-20748-01