Cisco 7604 Configuration Guide - Page 31

Quick Start Steps The following sections describe the minimum configuration required for the FWSM in routed mode or transparent mode: • Routed Firewall Minimum Configuration Steps, page xxxi • Transparent Firewall Minimum Configuration Steps, page xxxii Routed Firewall Minimum Configuration Steps To configure the FWSM in routed mode, perform the following steps: Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Step 8 Task Description Assigning VLANs to the Firewall Services Module, page 2-2 On the switch, you need to assign VLANs to the FWSM so that the FWSM can send and receive traffic on the switch. (Might be required) Adding Switched Virtual Interfaces to If you want the MSFC to route between VLANs that the MSFC, page 2-4 are assigned to the FWSM, complete this procedure. Connecting to the Firewall Services Module, page 3-1 From the switch CLI, you can session into the FWSM to access the FWSM CLI. (Might be required; multiple context mode only) Enabling or If you want to use multiple context mode and your Disabling Multiple Context Mode, page 4-10 FWSM is not already configured for it, or if you want to change back to single mode, follow this procedure. (Multiple context mode only) Configuring a Security Context, page 4-27 Add a security context. (Multiple context mode only) Changing Between Contexts and the System Execution Space, page 4-31 Because you must configure some settings in the system execution space and some settings within the context, you need to know how to switch between contexts and the system execution space. Configuring Interfaces for Routed Firewall Mode, page 6-2 For each VLAN interface, you must set a name (such as inside or outside), a security level, and an IP address. Configuring a Default Route, page 8-4 Create a default route to an upstream router. OL-20748-01 Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM xxxi