Cisco 7604 Configuration Guide - Page 60

Connecting to the Firewall Services Module Chapter 3 Connecting to the Firewall Services Module and Managing the Configuration To session in to the FWSM from the switch, log in, access privileged mode, and then configuration mode, perform the following steps: Step 1 Step 2 Step 3 Step 4 Step 5 Session in to the FWSM from the switch using the command appropriate for your switch operating system: • Cisco IOS software Router# session slot number processor 1 • Catalyst operating system software Console> (enable) session module_number For multiple context mode, when you session in to the FWSM, you access the system configuration. See Chapter 4, "Configuring Security Contexts," for more information. Log in to the FWSM by entering the login password at the following prompt: hostname passwd: By default, the password is cisco. To change the password, see the "Changing the Passwords" section on page 7-1. To access privileged EXEC mode, enter the following command: hostname> enable This command accesses the highest privilege level. The following prompt appears: Password: Enter the enable password at the prompt. By default, the password is blank, and you can press the Enter key to continue. See the "Changing the Passwords" section on page 7-1 to change the enable password. The prompt changes to: hostname# To exit privileged mode, enter disable. You can also enter exit or quit to exit the current access mode (privileged EXEC mode, global configuration mode, and so on). To access configuration mode, enter the following command: hostname# configure terminal The prompt changes to the following: hostname(config)# Logging out of the FWSM To end the FWSM session and access the switch CLI, enter the following command: hostname# exit Logoff Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM 3-2 OL-20748-01