Cisco 7604 Configuration Guide - Page 343

Chapter 16 Configuring NAT NAT Examples The FWSM already has a connected route for the inside network. These static routes allow the FWSM to send traffic for the 192.168.100.0/24 network out the DMZ interface to the gateway router at 10.1.1.2. (You need to split the network into two because you cannot create a static route with the exact same network as a connected route.) Alternatively, you could use a more broad route for the DMZ traffic, such as a default route. If host 192.168.100.2 on the DMZ network wants to initiate a connection to host 192.168.100.2 on the inside network, the following events occur: 1. The DMZ host 192.168.100.2 sends the packet to IP address 10.1.2.2. 2. When the FWSM receives this packet, the FWSM translates the source address from 192.168.100.2 to 10.1.3.2. 3. Then the FWSM translates the destination address from 10.1.2.2 to 192.168.100.2, and the packet is forwarded. Redirecting Ports Figure 16-28 illustrates a typical network scenario in which the port redirection feature might be useful. Figure 16-28 Telnet Server 10.1.1.6 Port Redirection Using Static PAT FTP Server 10.1.1.3 10.1.1.1 209.165.201.25 Web Server 10.1.1.5 Web Server 10.1.1.7 Inside FWSM Outside 132932 In the configuration described in this section, port redirection occurs for hosts on external networks as follows: • Telnet requests to IP address 209.165.201.5 are redirected to 10.1.1.6. • FTP requests to IP address 209.165.201.5 are redirected to 10.1.1.3. • HTTP request to FWSM outside IP address 209.165.201.25 are redirected to 10.1.1.5. • HTTP port 8080 requests to PAT address 209.165.201.15 are redirected to 10.1.1.7 port 80. To implement this scenario, perform the following steps: OL-20748-01 Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM 16-39