Cisco 7604 Configuration Guide - Page 294

Controlling and Monitoring Failover Chapter 14 Configuring Failover hostname(config)# no failover active group group_id Step 3 Step 4 Step 5 Use FTP to send another file between the same two hosts. If the test was not successful, enter the show failover command to check the failover status. When you are finished, you can restore the unit or failover group to active status by enter the following command: • For Active/Standby failover, enter the following command on the active unit: hostname(config)# failover active • For Active/Active failover, enter the following command on the unit where the failover group containing the interface connecting your hosts is active: hostname(config)# failover active group group_id Controlling and Monitoring Failover This section describes how to control and monitor failover. This section includes the following topics: • Forcing Failover, page 14-40 • Disabling Failover, page 14-41 • Disabling Configuration Synchronization, page 14-41 • Restoring a Failed Unit or Failover Group, page 14-41 • Monitoring Failover, page 14-42 Forcing Failover To force the standby unit or failover group to become active, enter one of the following commands: • For Active/Standby failover: Enter the following command on the standby unit: hostname# failover active Or enter the following command on the active unit: hostname# no failover active • For Active/Active failover: Enter the following command in the system execution space of the unit where failover group is in the standby state: hostname# failover active group group_id Or, enter the following command in the system execution space of the unit where the failover group is in the active state: hostname# no failover active group group_id 14-40 Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM OL-20748-01