Cisco 7604 Configuration Guide - Page 633

Appendix B Sample Configurations Routed Mode Sample Configurations Figure B-3 Example 3 Internet MSFC 209.165.201.2 VLAN 200 Admin Context Outside 209.165.201.3 Department 1 Outside 209.165.201.4 Department 2 Outside 209.165.201.5 Inside 10.1.0.1 VLAN 201 Shared 10.1.1.1 Inside 10.1.2.1 VLAN 202 Shared 10.1.1.2 Inside 10.1.3.1 VLAN 203 Shared 10.1.1.3 Config Server Admin Host 10.1.0.16 10.1.0.15 VLAN 300 Web Server VLAN 300 10.1.2.3 Shared Network Inside VLAN 300 132979 AAA Server Mail Server Syslog Server 10.1.1.6 10.1.1.7 10.1.1.8 See the following sections for the configurations for this scenario: • System Configuration (Example 3), page B-9 • Admin Context Configuration (Example 3), page B-10 • Department 1 Context Configuration (Example 3), page B-11 • Department 2 Context Configuration (Example 3), page B-12 • Switch Configuration (Example 3), page B-12 System Configuration (Example 3) You must first enable multiple context mode using the mode multiple command. Then enter the activation key to allow more than two contexts using the activation-key command. The mode and the activation key are not stored in the configuration file, even though they endure reboots. If you view the configuration on the FWSM using the write terminal, show startup-config, or show running-config commands, the mode displays after the FWSM Release (blank means single mode, "" means you are in multiple mode in the system configuration, and means you are in multiple mode in a context). OL-20748-01 Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM B-9