Cisco ASR1006 Configuration Guide - Page 386
Example: Frame Relay-to-ATM Bridged Interworking on an ATM-PE Router, Step 24
UPC - 882658196423
View all Cisco ASR1006 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 386 highlights
Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking Configuring MPLS Layer 2 VPNs Command or Action Step 24 no atm enable-ilmi-trap Step 25 Step 26 Example: Router(config-if)# no atm enable-ilmi-trap exit interface atm slot/subslot/port [.subinterface-number {point-to-point}] Purpose Disables the Integrated Local Management Interface (ILMI) ATM traps. Exits the interface configuration mode. Configures an ATM interface and enters the interface configuration mode. Example: Router(config)# interface atm 0/1/2.1 point-to-point Step 27 mtu bytes Adjusts the maximum packet size or maximum transmission unit (MTU) size. Example: Router(config-subif)# mtu 1500 Note The MTU sizes of both the attachment circuits must match. Step 28 no atm enable-ilmi-trap Disables the ILMI ATM traps. Step 29 Example: Router(config-subif)# no atm enable-ilmi-trap pvc [name] vpi/vci l2transport Step 30 Example: Router(config-subif)# pvc cisco 10/100 l2transport encapsulation encapsulation-type Step 31 Example: Router(config-if-atm-l2trans-pvc)# encapsulation aal5snap xconnect peer-ip-address vc-id encapsulation mpls pw-class pw-class-name Step 32 Example: Router(config-if-atm-l2trans-pvc)# xconnect 190.1.1.1 100 encapsulation mpls pw-class atm-fr-bridged exit Assigns a name to an ATM PVC, specifies the encapsulation type on an ATM PVC, and enters the ATM virtual circuit configuration mode. Sets the AAL5SNAP encapsulation (Any-to-Any) for the ATM point-to-point interface. Binds an attachment circuit to a pseudowire and configures an Any Transport over MPLS (AToM) static pseudowire. Exits to the global configuration mode. Example: Frame Relay-to-ATM Bridged Interworking on an ATM-PE Router The following example shows the configuration of the Frame Relay-to-ATM Bridged Interworking feature on an ATM-PE router: no ip domain lookup mpls label range 101 4000 static 4001 5001 mpls label protocol ldp mpls ip default-route mpls ldp graceful-restart xconnect logging pseudowire status ! Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide 10