Cisco ASR1006 Configuration Guide - Page 405
Enables the L2VPN Ethernet interworking feature., configuration mode.
UPC - 882658196423
View all Cisco ASR1006 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 405 highlights
Configuring MPLS Layer 2 VPNs Configuring Gigabit EtherChannel for Virtual Private Wire Service Command or Action Step 11 channel-group channel-group-number timeslots range Purpose Configures serial WAN on a T1 or E1 interface. Step 12 Step 13 Step 14 Example: Router(config-controller)# channel-group 0 timeslots 1-24 exit pseudowire-class [pw-class-name] Example: Router(config)# pseudowire-class atm-fr-bridged encapsulation mpls Exits the pseudowire class configuration mode. Establishes a pseudowire class with a name that you specify and enters the pseudowire class configuration mode. Enables MPLS encapsulation on the interface. Step 15 Example: Router(config-pw-class)# encapsulation mpls interworking ethernet Enables the L2VPN Ethernet interworking feature. Example: Router(config-pw-class)# interworking ethernet Step 16 exit Step 17 interface loopback loopback-interface-number Exits the pseudowire class configuration mode. Specifies the Loopback logical interface. Step 18 Example: Router(config)# interface loopback 0 ip address ip-address mask Specifies the IP address for the Loopback interface. Example: Router(config-if)# ip address 44.1.1.2 255.255.255.255 Step 19 exit Step 20 interface serial slot/subslot/port:timeslot Step 21 Example: Router(config)# interface Serial0/3/0:0 no ip address Exits the interface configuration mode. Specifies a serial interface created on a channelized T1 controller. Removes the previously configured IP address. Step 22 Example: Router(config-if)# no ip address encapsulation ppp Example: Router(config-if)# encapsulation frame-relay Configures the PPP (for serial interface) encapsulation on serial interface. Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide 29