Cisco WS-C2950T-24 Hardware Installation Guide - Page 114
Installing the Cisco Microsoft Windows Vista USB Driver
View all Cisco WS-C2950T-24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Connecting to a Console Terminal or Modem Chapter 3 Installing and Connecting the Router Step 1 Connect the end of the console cable with the RJ-45 connector to the light blue console port on the router. or Connect a USB 5-pin mini USB Type-B to the USB console port as shown in Figure 3-35, Figure 3-36 or Figure 3-37. If you are using the USB serial port for the first time on a Windows-based PC, install the USB driver now according to the instructions in the following sections. • "Installing the Cisco Microsoft Windows XP USB Driver" section on page 3-36 • "Installing the Cisco Microsoft Windows 2000 USB Driver" section on page 3-37 • "Installing the Cisco Microsoft Windows Vista USB Driver" section on page 3-37 Note You cannot use the USB port and the EIA port concurrently. See "Connecting to the Auxiliary Port" section on page 3-39. When the USB port is used it takes priority over the RJ-45 EIA port. Step 2 Step 3 Connect the end of the cable with the DB-9 connector (or USB Type-A) to the terminal or PC. If your terminal or PC has a console port that does not accommodate a DB-9 connector, you must provide an appropriate adapter for that port. To communicate with the router, start a terminal emulator application, such as Microsoft Windows HyperTerminal. This software should be configured with the following parameters: • 9600 baud • 8 data bits • no parity • 1 stop bit • no flow control 3-32 Cisco 2900 and 3900 Series Hardware Installation OL-18712-01