Cisco WS-C2950T-24 Hardware Installation Guide - Page 141

Chapter 4 Configuring the Router Performing the Initial Configuration on the Router line console exec-timeout 2 30 The following example shows how to set the console idle privileged EXEC timeout to 10 seconds: line console exec-timeout 0 10 Configuring Gigabit Ethernet Interfaces This sections shows how to assign an IP address and interface description to an Ethernet interface on your router. For comprehensive configuration information on Gigabit Ethernet interfaces, see the "Configuring LAN Interfaces" chapter of the Cisco IOS Interface and Hardware Component Configuration Guide, http://www.cisco.com/en/US/docs/ios/12_2/interface/configuration/guide/icflanin.html For information on interface numbering, see the software configuration guide for your router. SUMMARY STEPS 1. enable 2. show ip interface brief 3. configure terminal 4. interface {fastethernet | gigabitethernet} 0/port 5. description string 6. ip address ip-address mask 7. no shutdown 8. end 9. show ip interface brief DETAILED STEPS Command or Action Step 1 enable Step 2 Example: Router> enable show ip interface brief Step 3 Example: Router# show ip interface brief configure terminal Example: Router# configure terminal Purpose Enables privileged EXEC mode. • Enter your password if prompted. Displays a brief status of the interfaces that are configured for IP. • Learn which type of Ethernet interface is on your router. Enters global configuration mode. OL-18712-01 Cisco 2900 and 3900 Series Hardware Installation 4-13