Cisco WS-C2950T-24 Hardware Installation Guide - Page 206

Removing and Installing CompactFlash Memory Cards Chapter 5 Installing and Upgrading Internal Modules and FRUs Figure 5-44 CompactFlash Memory Card Slot in Cisco 2900 Series Routers DNOENTOWTORREKMOOPVEERDATUIROINNG DO NOT REMOVE DURING NETWORK OPERATION CF 1 1 2 DNOENTOWTORREKMOOPVEERDATUIROINNG CF 0 252299 Step 4 Step 5 Step 6 Press the ejector button again. See Figure 5-44. This ejects the CompactFlash memory card partially out of its slot. Pull the CF memory card out of its slot. Push the ejector button in until the button is flush with the bezel. Caution To prevent damage to the ejector mechanism, the ejector button must remain pressed all the way in (flush against the bezel) when not being used to eject a CompactFlash memory card. Installing a CompactFlash Memory Card To install a CompactFlash memory card, perform the following steps (see Figure 5-44): Step 1 Step 2 Read the "Safety Warnings" section on page 5-2 and disconnect the power supply before you perform any module replacement. Make sure that the ejector button is fully seated until it is flush with the bezel. Note If the ejector button is projecting out from the panel, push it in until it is flush with the bezel. Step 3 Insert the CompactFlash memory card into the slot until it is fully seated. The ejector button remains flush with the panel. Note If the ejector button is projecting from the panel after you insert the CompactFlash memory card, remove the CompactFlash memory card, press the ejector button until it clicks, and reinsert the CompactFlash memory card. Caution To prevent damage to the ejector mechanism, the ejector button must remain fully seated when not being used to eject a CompactFlash memory card. 5-54 Cisco 2900 Series and 3900 Series Hardware Installation Guide OL-18712-03