Cisco WS-C2950T-24 Hardware Installation Guide - Page 176
PVDM Adapter Components, Step 1
View all Cisco WS-C2950T-24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
Installing and Removing PVDM2s Chapter 5 Installing and Upgrading Internal Modules and FRUs Figure 5-18 PVDM Adapter Components 1 5 4 5 3 4 2 252842 1 PVDM adapter 3 Orientation notch 5 Guide posts 2 PVDM2 4 Guide post holes To install a PVDM2 into the PVDM3 slot, perform the following steps: Step 1 Step 2 Read the "Safety Warnings" section on page 5-2 section and disconnect the power supply before you perform any module replacement. Ensure that both retainer clips are open (the UP position). (See Figure 5-19, Figure 5-20, and Figure 5-21.) Figure 5-19 shows the retainer clip, connector clip, and guide post locations on the adapter. 5-24 Cisco 2900 Series and 3900 Series Hardware Installation Guide OL-18712-03
5-24
Cisco 2900 Series and 3900 Series Hardware Installation Guide
OL-18712-03
Chapter 5
Installing and Upgrading Internal Modules and FRUs
Installing and Removing PVDM2s
Figure 5-18
PVDM Adapter Components
To install a PVDM2 into the PVDM3 slot, perform the following steps:
Step 1
Read the
“Safety Warnings” section on page 5-2
section and disconnect the power supply before you
perform any module replacement.
Step 2
Ensure that
both
retainer clips are open (the UP position). (See
Figure 5-19
,
Figure 5-20
, and
Figure 5-21
.)
Figure 5-19
shows the retainer clip, connector clip, and guide post locations on the adapter.
1
PVDM adapter
2
PVDM2
3
Orientation notch
4
Guide post holes
5
Guide posts
5
5
4
3
252842
4
1
2