Cisco WS-C2950T-24 Hardware Installation Guide - Page 174
Installing a PVDM3
View all Cisco WS-C2950T-24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 174 highlights
Installing and Removing PVDM3 Figure 5-16 Removing a PVDM3 1 Chapter 5 Installing and Upgrading Internal Modules and FRUs 2 1 103466 1 Pull away the retaining clips 2 Pull out the PVDM3 Step 4 Place the PVDM3 in an antistatic bag to protect it from ESD damage. Installing a PVDM3 To install a PVDM3, follow these steps. Note Fill PVDM3s slots sequentially, starting with connector 0. Step 1 Step 2 Step 3 Read the "Safety Warnings" section on page 5-2 section and disconnect the power supply before you perform any module replacement. Locate the PVDM3 connector on the system board. See the "Locating Internal Modules" section on page 5-7 for the PVDM3 locations. Orient the PVDM3 so that the polarization notch lines up with the polarization key on the connector. See Figure 5-17. 5-22 Cisco 2900 Series and 3900 Series Hardware Installation Guide OL-18712-03