Cisco WS-CBS3020-HPQ Installation Guide - Page 53
Installing the Switch on the Wall,
View all Cisco WS-CBS3020-HPQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Chapter 2 Switch Installation Installing the Switch Figure 2-22 2 Mounting the Switch on a DIN Rail in a Parallel Position 4 1 3 1 15-mm DIN rail 2 Foot in extended position 3 7.5-mm DIN rail 4 Foot in recessed position After the switch is mounted on the DIN rail, connect the power and alarm wires, as described in the "Connecting Power and Alarm Circuits" section on page 2-32. Note For instructions on how to remove the switch from a DIN rail, see the "Removing the Switch from a DIN Rail or a Rack" section on page 2-31. Installing the Switch on the Wall To attach the switch to a wall or a panel, follow these steps. Warning Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the system. Statement 378 OL-13017-01 Cisco IE 3000 Switch Hardware Installation Guide 2-27