Compaq ProLiant 1850R Compaq ProLiant 1850R Setup and Installation Guide - Page 83
Adding Memory to the ProLiant 1850R Server, Table 3-2, DIMM Option Kit Part Numbers
View all Compaq ProLiant 1850R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
3-8 Installing Hardware Options 4. Press the module into the socket while pushing the latches inward until the latches snap into place . 5. Replace the server cover. 6. Push the server into the rack, secure with thumbscrews and reconnect cables. 7. Power on server and use the System Configuration Utility to reconfigure your system. Adding Memory to the ProLiant 1850R Server You can expand server memory by installing Compaq DIMMs (Dual Inline Memory Modules). The system supports up to four Registered SDRAM DIMMs installed in slots on the System Board. Memory can be added one module at a time. You must observe the following guidelines when installing additional memory: DIMMs installed in the ProLiant 1850R server must be 100-MHz registered SDRAM, 3.3-volts, 72-bits wide, and ECC. All DIMMs installed must be of the same speed, for example, all 100-MHz. The server is shipped with at least one DIMM in DIMM socket 1 (system board connector J12). DIMMs should be installed in sequential order starting with DIMM socket 1. Part Numbers 313613-B21 313614-B21 313618-B21 313616-B21 Table 3-2 DIMM Option Kit Part Numbers DIMM Option Kit Description 32-MB Option Kit 64-MB Option Kit 128-MB Option Kit 256-MB Option kit