Compaq ProLiant 800 ProLiant 800 Servers Supporting Pentium II Processors and - Page 16
Left Side Access Panel, WARNING
View all Compaq ProLiant 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
2-5 Left Side Access Panel Remove the left side access panel to access the IDE CD-ROM drive, power supply, riser board with tray, power switch and cable assembly, and 1.44-MB diskette drive cables. To remove the left side access panel: WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool before touching them. NOTE: The illustration below shows the tower model. Procedures are the same for the rackmountable model when removed from the rack. 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Unlock and open the front bezel door. 3. Loosen the two thumbscrews securing the left side access panel to the front of the chassis. 4. Slide the left side access panel back, then pull it away from the chassis. Figure 2-2. Removing the left side access panel Reverse steps 1 through 4 to replace the left side access panel. Compaq ProLiant 800 Servers Maintenance and Service Guide