Compaq ProLiant 800 ProLiant 800 Servers Supporting Pentium II Processors and - Page 76
Run the System Configuration Utility., Adapter/NVRAM
View all Compaq ProLiant 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
3-38 Diagnostic Tools DAAD Diagnostic Messages Continued Message Description Accelerator status: Cache was automatically configured during last controller reset. This can occur when cacheboard is replaced with one of a different size. Cache board was probably replaced with one of a different size. Recommended Action Nothing needs to be done. Normal operations should continue. Accelerator status: Valid data found at reset Valid data was found in posted write memory at reinitialization. Data will be flushed to disk. Not an error or data loss condition. No action needs to be taken. Accelerator status: Warranty alert Catastrophic problem with array accelerator board. Refer to other messages on Diagnostics screen for exact meaning of this message. Replace the array accelerator board. Adapter/NVRAM ID mismatch EISA nonvolatile RAM has an ID for a different controller from the one physically present in the slot. Run the System Configuration Utility. Battery X not fully Battery is not fully charged. charged Allow 36 hours to recharge them. Board not attached Array controller configured for use with array accelerator board, but one is not attached. Attach array accelerator board to array controller. NVRAM configuration present, controller not detected EISA nonvolatile RAM has a configuration for an array controller but there is no board in this slot. Either a board has been removed from the system or a board has been placed in the wrong slot. Place the array controller in the proper slot or run the System Configuration Utility to reconfigure nonvolatile RAM to reflect the removal or new position. Compatibility port problem detected Compatibility port configured for this IDA controller. When DAAD was verifying this interface, a serious problem was detected. A hardware problem has occurred; replace the IDA controller. Continued