Compaq ProLiant 800 ProLiant 800 Servers Supporting Pentium II Processors and - Page 43
POST Error Messages, Error Code, Audible Beeps, L=Long, S=Short, Probable Source of Problem - processor in incorrect slot
View all Compaq ProLiant 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
3-5 POST Error Messages Continued Error Code Audible Beeps L=Long S=Short Probable Source of Problem 162-System Options Not Set 2S Configuration incorrect. Recommended Action Run the System Configuration Utility and correct. 163-Time & Date Not Set 2S Invalid time or date in configuration memory. Run the System Configuration Utility and correct. 170- Expansion Device Not Responding None EISA or PCI expansion board failure. Check board for secure installation. Replace the failed board if necessary. 172- Configuration Nonvolatile Memory Invalid None Nonvolatile configuration Run the System Configuration Utility corrupt or jumper installed. and correct. 172-1 Configuration Nonvolatile Memory Invalid None Nonvolatile configuration corrupt. Run the System Configuration Utility and correct. 172-2 IRC Configuration Invalid None IRC enabled and video Move video controller to a PCI slot on controller is in PCI slot on the the primary PCI bus. secondary bus. 173- Slot ID Mismatch None Board replaced, configuration Run the System Configuration Utility not updated. and correct. 174Configuration/Slot Mismatch Device Not Found None EISA or PCI board not found. Run the System Configuration Utility and correct. 175Configuration/Slot Mismatch Device Found None EISA or PCI board added, Run the System Configuration Utility configuration not updated. and correct. 176-Slot with Not Readable ID Yields Valid ID None EISA or PCI board in slot that Run the System Configuration Utility should contain an ISA board. and correct. 177-Configuration Not Complete None Incomplete System Configuration. Run the System Configuration Utility and correct. 178-Processor Configuration Invalid None Processor type or step does not Run the System Configuration Utility match configuration memory. and correct. 179-System Revision Mismatch None A board was installed that has a Run the System Configuration Utility different revision date. and correct. 180-Log Reinitialized None N/A N/A Continued Compaq ProLiant 800 Servers Maintenance and Service Guide