Compaq ProLiant 800 ProLiant 800 Servers Supporting Pentium II Processors and - Page 33
Processor Power Module, Lift the processor power module from the system board
View all Compaq ProLiant 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
2-22 Removal and Replacement Procedures Processor Power Module The processor power module is removed for replacement or to replace the system board. To remove the processor power module: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Pull back the clips at each end of the processor power module . 3. Lift the processor power module from the system board . 2 1 Figure 2-20. Removing the processor power module Reverse steps 1 through 3 to replace a processor power module. The clips on the processor power module will snap into a locked position automatically when the processor power module is properly seated in its slot.
2-22
Removal and Replacement Procedures
Processor Power Module
The processor power module is removed for replacement or to replace the system board.
To remove the processor power module:
1.
Perform the preparation procedures. See
“
Preparation Procedures
”
earlier in this chapter.
2.
Pull back the clips at each end of the processor power module
.
3.
Lift the processor power module from the system board
.
1
2
Figure 2-20.
Removing the processor power module
Reverse steps 1 through 3 to replace a processor power module. The clips on the processor
power module will snap into a locked position automatically when the processor power module
is properly seated in its slot.