Compaq ProLiant 800 ProLiant 800 Servers Supporting Pentium II Processors and - Page 19
Top Access Panel
![]() |
View all Compaq ProLiant 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
2-8 Removal and Replacement Procedures Top Access Panel Remove the top access panel to access PCI and ISA boards, IDE CD-ROM drive cables, the I/O fan with bracket, and the power switch. WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool before touching them. To remove the top access panel: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Unlock and open the front bezel door. 3. Loosen the thumbscrew securing the top access panel to the chassis. 4. Slide the top access panel back, then away from the chassis. Figure 2-5. Removing the top access panel Reverse steps 1 through 4 to replace the top access panel.
![](/manual_guide/products/compaq-proliant-800-proliant-800-servers-supporting-pentium-ii-processors-100-mhz-bus-maintenance-service-guide-13a6d03/19.png)
2-8
Removal and Replacement Procedures
Top Access Panel
Remove the top access panel to access PCI and ISA boards, IDE CD-ROM drive cables,
the I/O fan with bracket, and the power switch.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
To remove the top access panel:
1.
Perform the preparation procedures. See
“
Preparation Procedures
”
earlier in this chapter.
2.
Unlock and open the front bezel door.
3.
Loosen the thumbscrew securing the top access panel to the chassis.
4.
Slide the top access panel back, then away from the chassis.
Figure 2-5.
Removing the top access panel
Reverse steps 1 through 4 to replace the top access panel.