D-Link 1824i User Guide - Page 38
Connecting Stations to the Hubs
![]() |
UPC - 790069210358
View all D-Link 1824i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
10BASE-T Stackable Hubs Plug the RJ-45 connector at one end into the network station, and the other end into a free 10BASE-T port on the front of the hub. When both the hub and the device at the other end of the connection are turned on, and the cable is connected at both ends, then the Link indication for the port should light. If it does not, then: 1. Be sure that the connectors are seated correctly at both ends of the cable. 2. Check the continuity of the wires in the cable, as well as the pin assignments on the RJ-45 connectors. 3. Be sure that the network station to which the port is connected is plugged in and powered on. 4. Check that the right type of cable is connected to the port and that the uplink switch is set correctly. Figure 5 -1 Connecting Stations to the Hubs 5-2 Network Connections
![](/manual_guide/products/dlink-1824i-user-guide-63af97f/38.png)