D-Link DGS-3630-52PC Quick installation Guide - Page 262

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide The fields that can be configured in ECMP Advance Control Mode are described below: Parameter ECMP Advance Control Mode Setting Description Select the ECMP advance control mode settings here. This specifies the number of ECMP or multipath routes and the number of next-hops of each ECMP or multipath route that will be changed according to the specified value. Options to choose from are 64, 128, 256, 512, and 1024. Click the Apply button to accept the changes made. IPv6 General Prefix This window is used to display and configure the VLAN interface IPv6 general prefix settings. To view the following window, click L3 Features > IPv6 General Prefix, as shown below: Figure 6-30 IPv6 General Prefix Window The fields that can be configured are described below: Parameter Interface VLAN Prefix Name IPv6 Address Description Enter the VLAN interface ID used here. The range is from 1 to 4094. Enter the IPv6 general prefix entry name here. This name can be up to 12 characters long. Enter the IPv6 address and prefix length here. The prefix length of the IPv6 address is also the local subnet on the VLAN interface. Click the Apply button to accept the changes made. Click the Find button to locate a specific entry based on the information entered. Click the Delete button to delete the specified entry. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. IP Tunnel Settings This window is used to display and configure the IP tunnel settings. 250