D-Link DWC-2000 User Manual - Page 112

Section 4 - Advanced WLAN Configuration Path: Maintenance > Firmware > AP Firmware Download > AP Firmware Status After the download begins, the AP Firmware Status tab will display information about the upgrade. Refer to the table below: Field Status (Global) Download Count Success Count Failure Count Abort Count Description Code Download Status The status of the upgrade process for all APs: • Not Started: The wireless controller has not started the download process. • Requested: A request to download AP software has been made, but the controller has not done any downloads. • Code Transfer in Progress: A download is in progress. • Failure: Download failed on all APs. • Aborted: Download was aborted before the AP loaded code from the TFTP server. • NVRAM‐Update‐in‐Progress: Download completed successfully. The reset command has been sent to the AP. • Success: All APs are connected to the wireless controller. The number of managed APs to download software in the current download request. If you selected All for the managed APs to upgrade, the download count shows the number of managed APs at the time the download request was started. The value is 1 if only one AP is being updated. The number of APs that have successfully downloaded the new code. This value starts with 0 at the beginning of the download and increases by one for every AP that successfully downloaded the code. The number of APs that failed to download the new code starting at 0 and incremental with each failure. The number of APs for which the download was aborted, starting at 0 and incremental each aborted download. D-Link DWC-2000 User Manual 112