D-Link DWC-2000 User Manual - Page 115
Network, IP Mode, IPv4 only, IPv4 & IPv6
View all D-Link DWC-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Section 5 - Advanced Network Configuration IP Mode Path: Network > LAN > IP Mode This page allows user to configure the IP protocol version to be used on the controller. In order to support IPv6 on the LAN, you must set the controller to be in IPv4 / IPv6 mode. This mode will allow IPv4 nodes to communicate with IPv6 devices through this controller. 1. Go to Network > IPv6 > IP Mode. 2. Next to IP Mode, select either IPv4 only or IPv4 & IPv6. 3. Click Save. D-Link DWC-2000 User Manual 115
D-Link DWC-2000 User Manual
115
Section 5 - Advanced Network Configuration
IP Mode
Path: Network > LAN > IP Mode
This page allows user to configure the IP protocol version to be used on the controller. In order to support IPv6 on
the LAN, you must set the controller to be in IPv4 / IPv6 mode. This mode will allow IPv4 nodes to communicate
with IPv6 devices through this controller.
1. Go to
Network
>
IPv6
>
IP Mode
.
2. Next to
IP Mode
, select either
IPv4 only
or
IPv4 & IPv6
.
3. Click
Save
.