D-Link DWC-2000 User Manual - Page 135

Section 5 - Advanced Network Configuration Port VLANs Path: Network > VLAN > Port VLAN After you enable the wireless controller's VLAN function, use the Port VLAN page to configure the ports participating in the VLAN. 1. Go to Network > VLAN > Port VLAN. 2. Select the port and right-click Edit. 3. Change Mode and PVID. There are four modes: • Access: Select to isolate this port from other VLANs. All data going into and out of the port is untagged. Traffic through a port in access mode looks like any other Ethernet frame. • General: Select to allow the port to become a member of a user selectable set of VLANs. The port sends and receives data that is tagged or untagged with a VLAN ID. If the data into the port is untagged, it is assigned the defined PVID. All tagged data sent out of the port with the same PVID will be untagged. • Trunk: Select to multiplex traffic for multiple VLANs over the same physical link. All data going into and out of the port is tagged. Untagged coming into the port is not forwarded, except for the default VLAN with PVID=1, which is untagged. • Interface: Select to make it as a standalone interface. Manually define the interface IP address, subnet mask, and gateway. 4. Click Save. D-Link DWC-2000 User Manual 135