Dell 5110cn Color Laser Printer Service Manual - Page 254

Chapter 3 Removal and Replacement Procedures (RRPs) 1.2 Description of procedure ‰ [RRP X.Y "AAAAA"] attached at the front of the procedure shows that the name of parts to be assembled/disassembled is "AAAAA". ‰ "(PL X.Y.Z)" attached at the end of parts name in the procedure shows that the parts corresponds to the plate (PL) "X.Y", item "Z" of [Chapter 5 Parts list], and their shape and fitting position can be checked in [Chapter 5 parts list]. ‰ Description of direction shown below is used in the procedure. TFront : Front direction when facing the front of device. TRear : Rear direction when facing the front of device. TLeft : Left direction when facing the front of device. Tright : Right direction when facing the front of device. Ten03097KA Figure: Definition of Printer Orientation ‰ Description of "‹[In the case of specification ***]" in the procedure shows that the work is performed only on the device with relevant specification. (no work is performed on device with irrelevant specification.) ‰ "(RRP X.Y) used in or at the end of sentences in the procedure shows that related work procedure is described in [RRP X.Y]. ‰ Screws in a diagram are supposed to be loosened and removed using a plus (+ screw driver), unless otherwise specified. ‰ Black arrow in a diagram shows the moving direction. Moreover, the order number attached to the black arrows shows the order of movement. ‰ Refer to [Chapter 4 Plug/Jack (P/J) Connector Locations] for the position of connector (P/J). 3 - 4