Dell 5110cn Color Laser Printer Service Manual - Page 621
Paper Mode, 10 Warm-up Time
View all Dell 5110cn Color Laser Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 621 highlights
Chapter 8 Printer Specifications 4.9 Paper Mode 8 paper modes are available for this printer. Modes are switched over under the instruction from the controller. Classification of paper mode (1) Plain paper-L mode : Plain paper such as FX-P, R, J/JD (for Japanese) whose thickness is 60-80 gsm. (2) Plain paper-H mode : Plain paper such as XC-4200 20lb, 24lbs RX-80, 90 (for overseas) whose thickness is 65-105 gsm. (3) Plain paper-H' mode : Plain paper such as XC-4200 20lb, 24lbs RX-80, 90 (for overseas) whose thickness is 24lb-28lb. (4) Thick paper-L mode : it is selected to run on the papers whose thickness is 106-163 gsm. (5) Thick paper-H mode : It is selected to run on the papers whose thickness is 164-216 gsm. (6) Label-L mode : It is mainly selected to run on Japanese labels (V860 etc.). (7) Label-H mode : It is mainly selected to run on labels (3R4469 etc.). (8) OHP mode : It is selected to run on OHPs (V516 etc). (9) Envelop mode : It is selected to run on envelops. (10) Postcard mode : It is selected to run on postcards. (11) Coated paper-L mode : It is selected to run on the coated papers whose thickness is 60- 105 gsm. (12) Coated paper-H mode : It is selected to run on the coated papers whose thickness is 106- 163 gsm. (13) Coated paper-H' mode : It is selected to run on the coated papers whose thickness is 164- 216 gsm. Relation between the resolution, process speed, print mode and paper mode is shown in the table below. Correspondence media mode Plain paper (1) Thick/Special paper (2) - (13) Print mode B/W full speed mode Color full speed mode Color / B/W medium speed mode Color / B/W low speed mode Process direction resolution/ Process speed B/W Color 600dpi 600dpi 264mm/s - - 225mm/s 132mm/s 132mm/s 88mm/s 88mm/s 4.10 Warm-up Time When the nominal voltage (100 V, 120 V or 220 V) is applied, the FUSER standby temperature should be reached within the time stated below. • From the moment of POWER ON to the start of Standby mode: 10 seconds or less • When a mode change command is received from IOT during the Power Save mode: 35 seconds or less Reference: Excluding the period of time required to adjust the color registration. 8 - 9