Dell Brocade 6510 Fabric OS Command Reference v7.1.0 - Page 200
for the peer. Node WWN/Slot, EE IP Address, EE State, and IO Link State. On a chassis with multiple
View all Dell Brocade 6510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 200 highlights
2 cryptoCfg NOTES OPERANDS • Group-wide policy configuration. • Zeroization of all critical security parameters on the local encryption switch or blade. • Certificate display and management. • Display of the local encryption engine status. • Rebalancing of disk and tape LUNS for optimized performance. • Configuring and running key vault diagnostics. Use the --show -localEE command to display encryption engine configuration parameters pertaining to the local node. The command displays the following information: • EE Slot: Encryption engine slot number. • SP state: Security processor state. For a complete listing of SP states, refer to the Fabric OS Encryption Administrator's Guide, Appendix A. • Current master key ID (or primary link key ID) - Key ID or zero if not configured. • Alternate master key ID (or secondary link key- Key ID or zero if not configured. • HA cluster name to which this EE belongs, or "No HA cluster membership". • EE Attributes: The following attributes are displayed: - Link IP Address: Link IP address - Link GW IP Address: Link gateway W IP address - Link Net Mask: Link net mask - Link MAC Address: Link MAC address - Link MTU: The maximum transmission unit of the link - Link State: DOWN unless the EE is part of an HA cluster - Route Mode: Always "shared;" this parameter is not configurable - Media Type: TAPE, DISK, DISK/TAPE, or NOT DEFINED - Rebalance Recommended: No, Yes, or EE Busy (unspecified, try again to determine rebalance recommendation) - System Card Label: Displayed only if a system card is registered - System Card CID: Displayed only if a system card is registered. Remote EE Reachability: If the EE is part of an encryption group, the following information is displayed for the peer. Node WWN/Slot, EE IP Address, EE State, and IO Link State. On a chassis with multiple encryption blades, remote reachability information is displayed for all encryption groups. The initial setup includes preparatory steps that are outside the scope of the cryptoCfg command. For preinitialization procedures, refer to the Fabric OS Encryption Administrator's Guide. The cryptoCfg node initialization and configuration function has the following operands: --help -nodecfg Displays the synopsis for the node initialization and configuration function. This command is valid on all nodes. --initnode Initializes the node to prepare for the configuration of encryption options. Initialization must be performed on every node before configuration options may be set and encryption may be enabled. This command prompts for confirmation, because the --initnode function overwrites any previously generated identification or authentication data on the node. Successful execution generates the node CP certificate, the key authentication center (KAC) certificate, the FIPS Crypto Officer, and the FIPS User key pairs. 172 Fabric OS Command Reference 53-1002746-01