Dell Brocade 6510 Fabric OS Command Reference v7.1.0 - Page 700
portCfgFaultDelay, portCfgShow, switchShow
View all Dell Brocade 6510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 700 highlights
2 portCfgFaultDelay portCfgFaultDelay Configures the fault delay for a single FC port. SYNOPSIS portcfgfaultdelay [slot/]port delay portcfgfaultdelay --help DESCRIPTION NOTES OPERANDS EXAMPLES Use this command to configure the fault delay of an FC port. In the event that the link is noisy after a host power cycle, the switch may go into a soft fault state, which means a delay of R_A_TOV. Setting the mode value to 1 reduces the fault delay value to 1.2 seconds. The configuration is stored in nonvolatile memory and is persistent across switch reboots and power cycles. Use the portCfgShow command to display the user-configured fault delay settings. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command is applicable only to Fibre Channel ports. This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port Specifies the number of the port to be configured, relative to its slot for bladed systems. Use switchShow for a listing of valid ports. delay Specifies the fault delay value for the port number. This operand is required. Valid values are one of the following: 0 Sets the fault delay to R_A_TOV (default). 1 Sets the fault delay to 1.2 seconds. ---help Displays the command usage. To set the fault delay of a port to 1.2 seconds: switch:admin> portcfgfaultdelay 2/3 1 To display the configuration switch:admin> portcfgshow 2/3 Area Number: Octet Speed Combo: Speed Level: AL_PA Offset 13: Trunk Port Long Distance VC Link Init 21 1(16G|8G|4G|2G) AUTO(SW) OFF ON OFF OFF 672 Fabric OS Command Reference 53-1002746-01