Dell Brocade 6510 Fabric OS Command Reference v7.1.0 - Page 75
agShow, World Wide Name
View all Dell Brocade 6510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
agShow 2 agShow Displays the Access Gateway information registered with the fabric. SYNOPSIS agshow agshow --name ag_name agshow --local DESCRIPTION NOTES This command displays the details of the F_Ports and the configured N_Ports in the Access Gateway attached to the fabric. The command output displays the following information. Name The name of the Access Gateway. NodeName The World Wide Name of the Access Gateway node. Ports The number of ports in the Access Gateway. Enet IP Addr The IP address of the Access Gateway. Firmware Current firmware running on the Access Gateway. Local/Remote Indicates whether the Access Gateway is locally or remotely registered to this switch. World Wide Name The world wide name (WWN) of the given Access Gateway. N-Port ID(s) The port ids of the N_Ports configured in the given Access Gateway. N-Ports The number of configured N_Ports that are online. F-Ports The number of F_Ports that are online. Attached F-Port information Displays the Port ID, the switch F-port number, and the Port WWN of each F_Port that is online on the Access Gateway. Access Gateway F-Port information Displays the port number, the port ID, and the Port WWN of the Access Gateway to which the F_Port is connected. This information is displayed only if both the Access Gateway and the switch to which the Access Gateway is attached are running Fabric OS v.7.0.0. The data in this section is not always synchronized with the data in the Attached F-Port information section. NPIV capability should be enabled on the ports connected to the Access Gateway. NPIV capability is enabled by default. Use portCfgNPIVPort to enable NPIV capability a port if it was previously disabled. Note that enabling or disabling NPIV capability is no longer supported in Access Gateway mode. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. Fabric OS Command Reference 47 53-1002746-01